CBAM Embedded Emissions Calculation in Iron and Steel
Iron and steel is the widest of the product groups covered by the Carbon Border Adjustment Mechanism (CBAM) and the sector where the calculation is most sensitive to the production route. A steel product of the same grade carries very different embedded emissions depending on whether it came from a blast furnace at an integrated plant or from scrap in an electric arc furnace.
What Drives the CBAM Calculation in Iron and Steel
A significant share of steel production in Türkiye runs on the electric arc furnace route, based on scrap. On that route embedded emissions are usually markedly lower than on the integrated route. Whether that difference shows up in the calculation, however, depends on the installation putting forward its own data; where data cannot be provided, default values are used.
On the blast furnace and basic oxygen converter route, the main source of emissions is the reduction of iron ore with coke; sinter, pig iron and, where needed, ferroalloys enter the calculation as precursors. On the electric arc furnace route the main input is scrap; emissions at the installation come from the melting process and fuel use, and direct reduced iron, where used, also enters the calculation as a precursor.
What CBAM Asks of Iron and Steel Producers
For iron and steel products exported to the European Union (EU), the CBAM declaration is made by the authorised CBAM declarant in the EU. What is asked of you as the producer is to calculate embedded emissions per product from your own installation data, and to document that calculation in a way an accredited verifier can verify.
For iron and steel products, only direct emissions count towards the obligation. Purchased electricity is shown separately in the report, but for this product group it is not added to the embedded emissions obligation.
For companies that buy semi-finished products, such as rolling mills or pipe manufacturers, the calculation chain extends to the supplier: the embedded emissions of purchased billets or flat products carry over into your product as precursors. Where real data cannot be obtained from the supplier, a default value is used for that item; because a mark-up is applied to default values in the definitive period, real data is in most cases the better option.
Alongside CBAM: Corporate Carbon Footprint and EPD
The carbon requests reaching steel producers do not stop at CBAM.
Product-level environmental declaration. Construction projects, green building certifications and tenders increasingly ask for an Environmental Product Declaration (EPD) for steel products. For an installation on the arc furnace route, this is a chance to show its low-carbon production in an independently verified document and to stand out in project procurement.
Corporate carbon footprint. Banks ask for a company's total emissions data in credit assessments, and large customers in the EU and Türkiye ask for it when choosing suppliers. Being able to present this data regularly and verifiably makes access to finance and to corporate customers easier.
Both requests build on the installation and production data you already keep for CBAM; there is no need to start a separate data collection exercise. For details, see the corporate carbon footprint and life cycle assessment pages.
Iron and Steel Calculation with S-CBAM
In S-CBAM you define your installation, products, production methods and production batches once. Periodic data is entered against these definitions, and the system does the calculation. Supplier data is collected for purchased semi-finished products; where no data can be obtained for an item, a default value is used. The result calculated from your own data can be compared with the default value.
For details of the module, see the S-CBAM page.
Frequently Asked Questions on CBAM in Iron and Steel
Does producing in an electric arc furnace show up in the result?
Yes. The production route is the main factor that determines embedded emissions. When the calculation uses your own installation data, that difference is reflected in the result.
What happens if our semi-finished product supplier cannot give us data?
A default value is used for that item. Since real data is in most cases more favourable, it is important to collect supplier data in good time.
Our customer is asking for an EPD. Is the work we did for CBAM any use?
Yes. The installation, product and production records you set up for CBAM are also the foundation of a product life cycle assessment.
Contact
Write to us to talk through how your production route affects the CBAM calculation and your other carbon requests. If you are unsure about scope, you can start with the CBAM pre-assessment.